In this case, execute the switchscf command to switch the master XSCF. If the serial number of the standby chassis is being used as the system serial number, the initbb command cannot release the standby chassis. The serial number of the chassis of either the master XSCF or standby XSCF is used as the system serial number.Multiple SPARC M10-4S units cannot be released from the system by using the initbb command at the same time. In case of resetting the configuration to the original setting, you can restore the saved setting information to XSCF by using the restoreconfig command. All the system setting information will be cleared and reset to the factory defaults.īefore removing the SPARC M10-4S, save the system setting information with the dumpconfig command.
0 Comments
Leave a Reply. |